061- thru 065-

061-310

Clapper Fail

An error occurred with internal ESS PWB processing.

061-315

SOS Long Fail

SOS Signal Interval is longer than spec.

061-319

SOS Short Fail

SOS Signal Interval is shorter than spec.

061-320

Polygon Motor Fail

The qty of Polygon Motor rotations did not become normal 4sec after Polygon Motor ON.

061-325

No SOS Fail

Not a single SOS Signal could be detected.

061-329

ROS Connect Fail

Poor connection between ROS LD and MCU PWB

061-330

Polygon Motor Lock Fail

With Polygon Motor OFF, Motor Ready Signal being Ready was detected three consecutive times.

061-331

ROS VDD Fail

Under one of the following conditions, ROS VDD Signal became active three consecutive times.

061-332

ROS VDD Down Fail

With Polygon Motor ready, ROS VDD Signal became inactive.

061-334

SOS Stop Fail

SOS Signal stops.

061-340

ROS LD Fail

When LD Alarm occurred, it was found that of 32CHs, 3CHs or more (NVM749-105) had LDs deteriorated.

061-603

ROS Data Fail

Serial data communication failed between MCU PWB and ROS. (Hidden Fail)

061-607

LD Alarm

One of 32 beams had an error. (Hidden Fail)

062-210

IISS Hot Line Fail

The open Hot Line Signal line was detected.

062-211

IIT/IPS EEPROM Fail (IPS)

An error occurred in writing onto EEPROM or communication with EEPROM (despite retries).

062-220

IPS-EXT Connection Fail

Poor connection between IIT/IPS PWB and Extension Memory PWB

062-277

IIT/IPS-DADF Communication Fail

A IIT/IPS PWB-DADF PWB communication failure

062-278

IIT-Extension Communication Fail

A IIT/IPS PWB-Extension MEM PWB communication failure

062-300

Platen Interlock Open

Platen Interlock is open.

062-310

IIT/IPS-ESS Communication Fail

A IIT/IPS PWB-ESS PWB communication failure

062-311

IIT Software Logic Fail

IIT/IPS PWB Software error was detected.

062-345

IIT/IPS EEPROM Fail (IIT)

An error occurred in writing onto EEPROM or communication with EEPROM.

062-355

IPS Fan Fail

IPS Fan failed.

062-356

Lamp Fan Fail

For Lamp Fan, error signal was detected.

062-357

CCD Fan Fail

For CCD Fan, error signal was detected.

062-360

Carriage Position Fail

With Carriage Position, an error was detected.

062-362

X Hard Fail

062-371 Lamp Fail

062-371

Lamp Fail

It was found that light from the lamp to CCD was not enough (in White Fluctuation Correction before the start of scan or in performing AGC).

062-380

Platen AOC Fail

Auto Gain Correction (AGC) Setup failed.

062-386

Platen AOC Fail

Auto Offset Correction (AOC) failed.

062-389

Carriage Over Run (Scan End)

Carriage overran the Scan End side.

062-392

IT/IPS Memory Fail

An IIT/IPS PWB RAM failure was detected (checked at Power ON), or an error occurred with internal IIT/IPS PWB processing.

062-393

IIT/IPS PWB Fail

An error occurred with internal IIT/IPS PWB processing.

062-790

X Detect Fail

The doc copy of which was prohibited was scanned.

063-210

Extension EEPROM Fail

Detected was an error in writing onto EEPROM on Extension Memory PWB or communication with EEPROM.

063-220

IPS-EXT Psync Fail

Under the following:

063-230

EXT Image Parameter Fail

With 1P DUP PWB installed, DIMM of an illegal memory capacity was installed on Extension Memory PWB.

063-240

EXT Image Parameter Fail

Extension CPU cannot load image parameters specified from IISS.

065-210

Extension Page Memory Fail 1

Detected was poor contact of DIMM 1 with Extension MEM PWB.

065-211

CIS Shading FROM Fail

Detected was a failure in 1P DUP PWB Flash ROM (which stores Shading Data).

065-213

CIS Output Level Fail

A lack of CIS light qty was detected.

065-215

Extension Page Memory Fail 2

Detected was poor contact of DIMM 2 with Extension MEM PWB.

065-216

Extension Page Memory Fail 3

Detected was poor contact of DIMM 3 with Extension MEM PWB.

065-219

CIS Black White Level Fail

CIS Black Correction or White Correction is not complete.

065-220

1P DUP PWB-EXT Psync Fail

In Psync from 1P DUP PWB-EXT to Extension, there occurred an output error with 1P DUP PWB or an input error with Extension.